Nucleus Kernel Macintosh - Data Recovery Software provides you with the option to configure the software to ease the process of recovery. It provides the various options to have a control over the whole recovery process. To configure the software you can follow these steps:
Click Tool Menu > Settings
or
Click Setting buttonfrom the Toolbar, then it displays the following screen:
In the above screen, there are few options to configure the software:
Sectors to read in single attempt
This is the setting for the number of sector(s) to read in a single attempt. Increasing this value will make the software run faster. But in general this value should be set to a lesser value in the disks with bad sectors; you can increase this value for disks with good physical condition for faster recovery.
Settings of duplicate file(s)
This is the setting for duplicate file(s), there may be a situation that the folder where you are recovering the files may contain file(s) with the same name.
• By default the selected option is Rename Duplicate File(s) , so it renames the file(s)
• By selecting Overwrite Duplicate File(s), it overwrites the existing file(s) with the new file(s).
• By selecting Skip Duplicate File(s), it will not save those duplicate file(s).
Settings for Bad sectors
Number of retries on bad sector(s): This is the option that how many times the software will try to read a sector if the sector is not readable in single attempt.
Introduction 
